N8in8tor,
The pictures side by side I just dropped in and drag the corners to where you want them. I didn't really have to do anything special I noticed.
JMJNet,
I don't think there is a better equipment for replacing the transistors. Soldering the pins to the board is as good as the OEM...
Sorry I didn't feel like editing a video or uploading it, but you can see the alternator cooling fan is obviously spinning. I know anyone could pop the covers off of the transistors and hook up a new PMD to show a truck running.
Put your covers transistor covers back on your PMD and put it in...
8) Apply a bit of flux to each pin to help the heat transfer into the transistor lead from the soldering iron and solder the transistor leads to the circuit board. Just a tiny ball of solder on the tip of the iron is sufficient to solder the connection and will travel down the lead to the board...
Okay guys, I finally had a chance to play with some PMDs. The first one I repaired was a 2 beer job. The second without pictures was 10 minutes (could be 2 beers if you so choose). Both worked upon plugging into the truck in the block below. Both did not work prior to. This repair replaces...
I've been an aircraft and heavy equipment mechanic for 20 years. I'm not trying to reinvent the wheel, just keep it rolling. Never fear, I'm not going to put a starter in the valley!
Hi, everyone.
I've been away for a couple of years obtaining a mechanical engineering degree and working full time, which didn't leave much time for fun things (as in zero). Well, that's all over with now, and I have time to play. I have learned tons of stuff from this forum over the years...
Found the little culprit. Wire broken but the coating was not about 1 foot from the trans pass through connector. Cleaned it up, soldered, and heat shrunk. SHifted into OD like a champ. Still shifts into 2nd really hard. How can I adjust that?
Truck shifted beautifully before doing electronics in the trans except for no torque converter lockup. I am putting it back together again today and I will let you guys know what is up. If I need a PCM I'll let ya know, but this one tested fine. It sounds like a good deal tho'. Thanks for...
Does anyone have a mainfold pressure switch laying around that you can check the resistance between the pins. I can't find anything online or on AllData for a check for it. Thank you.
Troubleshot all of the wiring to the trans from the pcm and found an enomily in the internal harness to the manifold pressure switch which was replaced. Had to drop pan again to see if it was pinched wires in the harness or the actual brand new switch. Two pins on the switch had continuity...
Speedo is working fine, but the cruise has been working intermittently. I guess I am partially inept. I need to put the vehicle on jack stands and run it while checking the voltage or resistance from the sensor on the transfer case? By the way, doesn't it seem strange that all of this would...