Recent content by 6fiveturbo

my 95 one is aluminum, would it fit if i had anither like it?

my window motors are super slow. sometimes my passenger one won't even make it all the way up. what could be the cause of this?

anyone know where to get the front sloped skidplate at? my plastic one is broke and am in nedd of another can be metal or plastic but still relativly cheap

it is, but i was also gonna take out and clean out my ac core and fix a vent door while i was at it..if its all accessable

gee that makes me feel better about it.... haha

how hard is it to get to? is it easier to remove the dash to get to it or try and go through the bottom some how?

agreed lol but i didnt know if someone actually new the deminsions compared to say an ATT or an HX35?

what is the size (mm) of the stock turbo? i hear cummins ppl talk about 64mms and 72mms upgrades for theres and talk about how small a stock 6.5 turbo is compared to a stock cummins one. so just wondering our size lol

the o-rings on the top , the one for the fuel heater, and the one for the WIF sensor, can they be found at almost any parts store (ex. carquest) or are they some type of special deal?

so you make the tab longer or shorter?

which way is the coil turned? not quite sure how to do this mod..

check this out http://www.cumminsforum.com/forum/94-98-tech-articles/127099-running-no-plate.html

how hot do these get? and what temperture does it normally charge the air to?

how bout this..someone buy me an att and install it, then in a week someone also buy me a holset and instal it..then in another week i'll tell you which i like best and give the other one away :rofl: :lmao: :hihi:

thanks, what fitting should be screwed in the bottom one? and what size did you drill the side holes to?