4L80 rebuilt 2 years ago that has less than 2000 miles on it. Comes with a GearVendors overdrive unit, TCI TCU trans control, front and rear HD bumpers and a few sets of rims. No rust but has a little body damage but it doesn’t hinder driving. Bed has a 75 gallon stainless fuel tank tapped into...
had a hard rain last week, had windows down. tried to use cruise later that day but wouldn't engage. didn't see a fuse.
where should i start and what do i look out for.
took the trans out of the 96 and put it in the 93. hooked up the tcu and on the handheld it shows that it's always in 2nd gear. there are no trouble codes. it doesn't engage in gear no matter which gear i select.
in park it doesn't roll and does roll in neutral like normal. watched the selector...
There's the hot wire from the main harness, CSA, temp sensor with 2 leads on the crossover and the fast idle solenoid. What it the correct way to get them back together? Putting it back on because of the cool weather that was here for 2 days. Never put it on after i got it running again. Made a...
Just a project right now, sitting in the driveway, in my way. Would like to get it running before I sell it or I could part it out. LMK.
Asking $1,500.00 as is.
Bought in 2000. It was a farm truck in it's previous life and originally had leather. Drove it daily until fuel went up so I bought a...
thought i'd start this thread with... What did i do...
replaced the door roller hinge thingy....
went from this:
to this:
still creaks when i open the door but i will straighten it out.
couldn't figure out how to drive the pin all the way.
also got this in the mail:
hard to see at night...
Brand new but no box. Brackets included.
Here's the link on mfg site:
http://www.genssiled.com/shop/240w-led-spotflood-combo-light-bar-black/
I will post pics tomorrow when there's light (pun) and tomorrow night of the output.
I got this in a trade and selling for same amount mine was worth. I...
i have done both per these instructions:
"Transfer pump: This increases case pressure. Looking at intake of pump inside inlet fitting, there's a 5/32 allen screw, turn clockwise looking at it, increasing case pressure and timing advance across board. Be careful, too much and it will blow seals...
while just getting it on the road after sitting 4 years, it has had a hard problem when cold.
also have a noise from the engine. sounds like lifter or injector. i have a good full set of injectors on hand if it turns out to be the problem. here's a vid. much louder in person:
wondering if the...
gonna start this with intention toward info regarding my black exterior, gray interior, 1993, 4 door, 1 ton, long bed, 6.5 TD....
it's been sitting 4 years plus because i had a TDI Jetta to drive. i was getting over 50 mpg while driving 600 miles/week. couldn't afford to drive the truck, so it...
93 truck's been sitting 4 years now. it quit on me and figured it was the fuel. removed the IP inlet screen expecting it to be full of poop but it wasn't. jumped the gun and swapped IP and used the same top cover with original solenoids. jumper to start solenoid gets just a spark. remove cover...
while camping at Bright Sand Lake Regional Park, close to St. Walburg, Sk, i spotted a bumper made of aluminum. web site has no prices posted but they look pretty HD. the only thing i didn't like was the 70's looking lower valance, i would cut that off.
anyone had any experience with...
finally tried to start the 96 after removing/replacing the burned wires. crank but no start. crack ffm to check for air, looked like water. open ffm drain into clear container: looked like a glass of Dasanti! i drained 5 gallons so far. here a video...
i have been running wvo mix for a few months but have decided it's not worth it, between fuel filter changes and being stranded, those days are over. think i have IP damage but i want to rule out anything else.
after it sits overnight, it will start pretty easy, just a few revolutions. after...
after shut down, my fuel pressure quickly drops to zero after just 2 seconds. is there normally pressure left in the line? i had a no crank after it died after driving for an hour. after 8 hour sitting, it started after many cranks but died after gear select. finally started after much cranking...
i put in a new one earlier this week because the other was weeping. it has a 99 engine so i put in a duplicate later style pump. i like the spin-on fan. was losing coolant out the rad cap and couldn't figure why. searched everywhere on the web but couldn't get an answer. the later pumps are...
in the cab of a tow truck. same thing yesterday. thought it was the lp, gauge showed zero pressure. changed it, was t it so changed filter. pressure showed 7. all good, i thought. drove in this morn, 45 miles down the road rpm/speed starts falling. made it to work, max speed 20. drovt to flaps...
here's an excerpt from the PDF:
2.2.8 Manual Shift Connection (Optional) – C8
The TCU is configured such that it's possible to have fully manual upshifts and downshifts at the flick of a
switch like a bump stick. This works by first activating the manual mode with one switch to Terminal C...