In 05 Suburban. Rough idle all of a sudden yesterday. Pulled the code and seems to point to Bank 1 position 1 which should be driver side before catalytic convertor if I am not mistaken.
Is that a 2131702 o2 sensor...
My PMD has been bolted to the skid plate for 20 years but will need to be relocated because one of my next steps will be to add an intercooler which will find its home there.
What is the consensus for the next best location for the PMD on the big aluminum heat sink?
The old style requires the original retaining ring
The newer style comes with its own built in ring
It looks like it actually comes with this new seal with WIX
I don't remember seeing a new o-ring in the Baldwin box.
Do both require a seal on top of the FFM?
I've replaced these a number of...
Does anyone have any idea of the blind nuts that are here for attaching the grill are available? This is about the location and would be on '94-'99 I suppose. They're just under this top edge of the core support.
As you can see, I have a gap after bolts are tight. Can the gasket between the downpipe flanges be doubled up?
The metal has deteriorated and scaled away.
In the past, I had learned that when replacing a blower motor, the only blower motor to use is an OEM part and I made it a rule because aftermarket simply didn't make a quality blower motor. They were either noisy during operation, they vibrated or the fins were brittle and easily broke apart...
2005 Tahoe - 5.3 with +308,000 on the odometer
Two times in the past week or so, when slowing down to stop the engine acts as if wants to die. The first time it happened as I pulled up to a stop light in town and it just stalled. I put in park, started it up and drove away. I continued with...
There is a clamp for this harness but I'm unsure where it is to mount. It must have needed to be moved to get the engine out, though, but I can't identify where it lived. It seems to have had a 8mm flange nut on one side but I don't know about the other. Below is a photo of about where it has...
I'm planning to replace this with a hose without the factory quick connects. For those that have done this, is regular heater hose being used? The routing seems like it could cause a possible kink.
I don't know where these go. I have figured out where the big cast brackets go, but don't know about these. One is for power steering pump I think. Any hints would be greatly appreciated.
I went out to start my little truck yesterday and I noticed the 4wd selector lights flickering at me, then when I hit the key, nothing. The older vehicles would start to show signs but with these newer ones, when they're done, they're done. Kind of a hassle, but could have been worse...
I purchased the Quadstar fuel log for my return line setup but am having a hard time determining how to route the lines. I would like to have the lines underneath the intake manifold but the block is so bulky that I'm not sure that is possible. Does anyone have pictures of a clean setup?
I'm...
I ordered the wrong oil filter adapter o-rings. Apparently those for the HMMWV are different from those of the truck adapter.
The one on the left is from my truck and the one on the right is the donor HMMWV.
Is 23500360 the correct number for the center bolt on the left, as well as the groove...